Wall to Glass Support Bar | Adjustable Shower Support Rod Manufacturer China

The threaded section gives a practical adjustment range for on-site fine-tuning, typically enough to cover a few centimeters of measurement or wall error. The exact range depends on the bar length ordered; we state the usable range on the drawing.

The bar is made from materials with strong corrosion resistance. SS304 and SS316 resist the humidity, soap and cleaning agents in shower rooms, and plated brass holds up when the plating is maintained. For coastal areas we steer you to SS316.

Tiled walls over concrete or brick, plasterboard and timber are all feasible, with different wall plugs supplied for each. The wall plate spreads the load so the screws are not pulled out of soft substrates. Tell us the wall build-up when ordering.

Yes, it is designed for frameless shower systems where the glass has no frame to lean on. The bar provides the missing structural tie between wall and glass while keeping the frameless look.

The glass clamp fits the glass thickness you specify; standard frameless shower panels are in the 8-12 mm range. Confirm the thickness with the order and we supply pads that match, so the clamp sits evenly and never pinches the edge. The same rule applies whether you run the bar wall-to-glass or glass-to-glass, since the clamp hardware is the same on both ends.

Production is 15-25 days from drawing approval. A single sample is available first (a sample fee may apply) to check length, finish and the adjuster action before you commit to the full order.