135 Degree Shower Door Hinge Frameless Glass Hinge

135 degrees opens wider than 90 degrees but stops short of folding flat. It suits shower doors that open into a small bathroom where you want a generous entry but do not want the door swinging all the way back against a wall, vanity, or second panel. The hinge holds the door at a predictable open position, which also helps keep the door out of the water spray area.

This model is a standard-pin hinge with no spring - the door stays where you leave it. If your installation needs a self-closing door or a free-swing door, we make those as separate series. Tell us how the door should behave and we will recommend the correct model rather than fitting a spring to this one, because the pivot design differs between the versions.

For a normal bathroom, SUS304 stainless gives the best balance of corrosion resistance and cost. SUS316 is the pick for coastal or pool areas; brass suits customers who want its warmer, machined look; zinc alloy keeps the price down for lower-use installations. The 135 degree hinge is produced in all four materials, so pick by environment and budget - the drilling pattern stays the same.

It fits 8-12mm tempered glass, the standard range for frameless shower doors and bathroom glass. The two clamp leaves grip the panel with rubber gaskets and through-bolts that go into drilled holes. Glass must be drilled before tempering using the drilling drawing we supply. For a door this size, two hinges are typical - three for tall panels.

Yes. Standard finishes are Brushed Bronze, brushed nickel, chrome, and gun gray, and we can run custom colors to match your fixtures. To match a specific tone, such as a particular gold or matte black, send us a sample of your existing hardware and we will tune the finish on an OEM order. Custom colors are produced with a 500-piece minimum.

Yes. Samples start at 1 piece; a sample fee may apply and it is refundable against a production order. Standard production runs from 50 pieces, and OEM orders with custom colors or your logo start at 500 pieces. Lead time is 15-25 days. Confirm the glass thickness with the sample order so the drill pattern is set up correctly.